Grab ‘n’ Go: Tape Sit-Upon SWAP

For little fingers, this might be the easiest sit-upon SWAP yet.

Tools:

• Scissors
• Sharpie or other permanent marker

Materials:

• Duct tape, decorative
• Fun foam square
• Safety pin

Steps:

Fun foam — Find or cut out a fun foam square that is not as wide as the tape you’re using.

Add tape — Center foam on tape and press. Put a second piece of tape on top. Alternatively, you could fold the tape over the foam square. Be sure all edges are completely sealed. Trim tape edges about a quarter to half inch from the edge of the square.

Faux stitch — Using the marker, make lines so it looks like stitching around the edges.

Add pin — Put safety pin through edge where it is two thicknesses of tape.

To download a PDF of this Grab ‘N’ Go sheet, click here: GnG_Tape SitUpon SWAP_lrl